1986 Ski-Doo Factory Shop Manual, Page 462Get this manual
Section 06 SUSPENSION Sub-section 08 (TRACK)
Citation LS, LSE, Tundra, Tundra LT
Remove tria following items:Battery lis So equipped)Chaincase Cover ,sprockets, cnainMufflerUpper center idler ass'ySuspension
If applicable, ensure thaI the link plate spnngs are in the middle position oflhe position slatted anchors, To correct track tension, loosen link plate spring lock nuts on inner side of link plate springsTurn adjuster bolts clockwise to tighten track or counterclockwise to slacken
Tension (bogie whee!), Alpine
With rear of vehicle blocked off the ground, check the tension of each track: 57 mm (2 14"1 between top inside edge and bolt of center whee! set retaining bait
- End bearing housing
- Both drive axle sealsDrive axle (outwards from end bearing housing)Track
INSTALLATION
All models:
Reverse the removal procedure
NOTE: When Installing the track, ensure the fight ,angle of bearing surface of the track rib :::; facing the front of vehicleFront