1986 Ski-Doo Factory Shop Manual, Page 443Get this manual
Section 05 SUSPENSION Sub-section 05 (PRS SUSPENSION)
13,14, Housingnut
Always torque nuts to 10 N.m (89 Ibf.in)
6,83,84,85, Screw, inner spacer, rear axle &
outer spacer
To remove:
6,9.10,11,30,70.71, 74,86, Screwidler
wheel,snap ringbearing
To remove bearing from an Idler wheel:Unscrew retaining screw
- Unscrew retaining screw- Pull idler wheel- Remove the runner to take the rear axle offAt assembly, reverse the procedure, However pay tion to the following:Position inner and outer spacer as shown(TYPICAL)
- Pull the idler wheel outward, Using puller or by striking with piece of wood and hammer,Remove the snap ring then the bearingAt assembly reverse the procedure
NOTE: To remove the front idler wheels cross shatt, the runner must be removed (the cross shaft is shouldered)
Ticker section: either on top or al the bottom
42,44,45,57,69,75,80,81 Screw, bushing, nut, rear shackle, rear arm, rear shockspacer
To remove rear shock:Withdraw spacer from shock pivot