1986 Ski-Doo Factory Shop Manual, Page 423Get this manual
Section 05 SUSPENSION Sub-section 03 (TRS SUSPENSION)
DISASSEMBLYASSEMBLY
34, Stopper strap
Inspect strap for wear or cracks, bolt and nut for tightnessIf loose, inspect hole for deformation, Replace as requiredMake sure it is attached through the 2nd hole from the end and its corresponding hole "B" torque nut to N-m (89 Ibf-in),
Flat head punch
ISl hule
AOO700S002
7,8,48, Reinforcement strips, rivetsreinforcement bracket
To remove rivet use 316" dia, drillAt assembly, secure reinforcement brackets to runner with two (2) 10-32 12" bolts and nuts, and five (S) bolts and nuts for the reinforcement strips, Position bolt head outside of the runner
1 ,2,3,4,5, Runners, slider shoes, screws, stop nutsspirol pins
To replace worn slider shoe, remove the rear spirol pin, the front screw and stop nut then slide the shoe rearwards out of the runner,
46,50,51, Schock absorber, clevis pin