1986 Ski-Doo Factory Shop Manual, Page 418Get this manual
Section 05 SUSPENSION Sub-section 02 (SLIDE SUSPENSION)
Replace the screwdrIver by the ngm
Insert screwdriver on one side 10 rnainlain cross sha!
A003OO5OO6
12,36, Screwsliding support
Slide rear arm side with sliding suppor1 over slider padsRe-install removed sliding support and screwTorque screw to 48 N.m {35 Ibf-ftl, CAUTION: Make sure slider pads 36 are well installedCheck sliding action when sliding supports are installed
NOTE: For an easy installationa gap should exist between the spring end and the frameThus no pressure acts on the suspension
- Heposltlon vehicle on groundRemove chaincase and oil injection reservoir vent hole wires