1986 Ski-Doo Factory Shop Manual, Page 416Get this manual
Section 05 SUSPENSION 02 (SLIDE SUSPENSION)
29,34, Rear armscrews
Remove both screws securing tear arm to framePlug vent holes in chaincase filler cap and oil injection reservoir cap with wire to prevent leaksUsing appropriate equipment, lift rear of vehicle at least 110 em {43 in)
1 Nom 162 Ibf.po I
MOOOO5018
110 em 143 inl
1,2,3,4,8,9,10, Runners, slider shoes, stoppers, screwsstop nuts
To replace worn slider shoe, remove the stopper fasteners, the front screw and stop nut then slide the shoe rearwards out of the runner
AO!l3006013
Slider shoes must always be replaced
Check that there is gap between springs end and the frameThus no pressure acts on Ihe suspension,