1986 Ski-Doo Factory Shop Manual, Page 346Get this manual
Section 03 TRANSMISSION Sub-section 08 tGEARBOX)
NOTE: Assembled bearing must not project out of
planet wheel
6, Transmission lever handle
Put loctite 242 on handle threads
20,36, Carrier assembly
Apply Loctite 242 in planet wheel shaft boresWith planet wheel installed on shaft, press shaft into carrier boreApply Loctite 242 on shaft threadsInstall and torque nut to 35 N-m (26 Ibf-itl
47, Tensioner ass'y
Ensure that roller turns freely
67, Grease fitting
At grease fitting assembly, apply grease fitting threadsLoctite 242 on
21, Planet carrier bearing
With suitable pusher, press bearing inlO carrier bore and lock in place with .snap ring
66, Seal (countershaft)
Install seal in transmission case so that the seal rib is seated In the bore groove
18, Ring gear needle bearing
The bearing IS press fitted Into the ring gear and must be pushed down only from its stamped end
'W'CAUTION: Never pound the bearing into its housing with hammer or other impact tool,even in conjunction with the proper assembly mandrel