1986 Ski-Doo Factory Shop Manual, Page 312Get this manual
Section 03 TRANSMISSION Sub-section 06 (BRAKE)
, Cable 2, Ferrule (cable housing) 3, Ferrule {cable} 4, COtter pin (2) Brake mounting bracket
0, Pin 7, Shim (as required) 8, Flar washer rom (3) 9, Elastic stop nul rom (3) 70Flat washer 10 mm 111
II, Brake lever and pad 12, Brake switch bracket 13, Teprice screw M4 11'8 12J
18, Elastic stop nut 10 mm 79, Pulley shaft 20, Spring washer 11) 21Pulley
14" 15, 16, 17,
Bushmg Release spring Brake lever and pad Flat washer 10 rom 111
2223, 24, 25,
Srop plaCe
Corter pin (1)
AdJuSfing sleeve Circip
REMOVAL
Brake assembly
Disconnect brake light switch at connector and remove brake retainer nut, then pull out brake assembly, light switch and cable, Disconnect and remove brake cable,
22, Stop plate
Make sure the guard lock tab is inserted in the brake lever hole
18, Elastic stop nut
Torque to 12 N-m (106 Ibf.inl
WARNING: Always readjust the brake light switch after removing the brake assembly
INSTALLATION
Reverse the removal procedure paying particular attention to thefollowing: