1986 Ski-Doo Factory Shop Manual, Page 305Get this manual
Section 03 TRANSMISSION Sub-section 05 (PULLEY DISTANCEALIGNMENT)
Pulley distance adjustment method
Slack the four (4) chalncase retaining bolts, Unlock and raise pulley support
SKANDIC 377
Move chaincase to obtain specific adjustment and adjust driven pulley support accordinglyUnlocK and
001003004
Driven pulley
movement
Pulley distance specification Z= 41.3 mm3.17 (1 58"118)
Pulley alignment specification
Citation LSTundra, Tundra LT X=34.03 mm .38 (1 11'32" 164") Citation LSE
As space between inner half and ring gear is very small, given measure includes ring gear
Pulley distance adjustment method
Oversize holes on countershaft support and slotted lugs on chaincase casting allow movement of the countershaft
X= 45.30 mm 0.38