1986 Ski-Doo Factory Shop Manual, Page 304Get this manual
Section 03 TRANSMISSION Sub-section 05 (PULLEY DISTANCEALIGNMENT)
ELAN 250
CITATION LSE, TUNDRA, TUNDRA LT
Drillen pullev
mOlement
Driven pulley movemenl
Dr,ve pulley
AOO400300]
movement
Pulley distance specification
Z= 44.45 mm
(1 314"9116)
'W CAUTION: The rear suspension must be mounted on the vehicle and track tension and alignment
must be done to provide the right frame width
Pulley distance adjustment method
With the threaded rod and nut located between chaincase and frame, shih chaincase to obtain the specified distance
NOTE: Before checking pulley alignment, the distance between the two (2) front engine support must equal 302 mm (n89D" ,039)
302 mm 1;;-1 (11.890" .039)