1986 Ski-Doo Factory Shop Manual, Page 297Get this manual
Section 03 TRA.NSMISSION Sub-section 04 (DRIVEN PULLEY)
ASSEMBLY
7, Sliding half bushing
Assemble new bushing using press and suitable pusherSecure with Loctite 601 and stake with center punch on both flanges (6 points per side)
NOTE: PUlley alignment bar, see section 03-05, must be inserted between driven pulley halves before measuring end playSpacer PIN 504 1244 00 Shim PIN 504 0552 00
las required)
Contacl
2 shims PIN 504 0552 00
.0010Q3OO7
10, Cam slider shoe
When replacing slider shoes, always install new set (3 shoes) to maintain equal pressure on the cam
CAUTION: Pulley alignement should always be checked when ever pulleys have been removed replaced or disassembledFor pulley alignement procedure see section 03-05
1Countershaft
CAUTION: Always apply anti-seize compound on the counters haft before final pulley installation (loctite anti-seize lubricant PIN 413 7010 001