1986 Ski-Doo Factory Shop Manual, Page 296Get this manual
Section 03 TRANSMISSION Sub-section 04 (DRIVEN PULLEY)
REMOVAL
To remove driven pulley assembly; carburetor, air silencer and steering column must to be removed in the following sequence:
Remove spacers and save for reinstallation, see "Cam slider shoe adjustment"
INSPECTION
7, Sliding half bushing
Check sliding half bushing wear, replace bushing If wear is excessiveTo disassemble worn bushing, use press and suitable pusher
Pulley guarddrive belt
Remove from vehlcleo
Air silencer
Remove from vehicle
Carburetor
Disconnect carburetor rubber coupling at engine and move asideo
Steering column
Disconnect steering column upper and lower attaching bracketMove steering to the foremost right
NOTE: To obtain maximum steering movement, turn skis full right prior to removal of steering column
10, Slider shoe
Slider shoe must be replaced when dimple in the working surface is barely visible or worn to less than 31 of it's original depthSee illustration