1986 Ski-Doo Factory Shop Manual, Page 293Get this manual
Section 03 TRANSMISSION 04 (DRIVEN PULLEY)
Torque to 30 N-m
A007oo3010
50.8 mm (2.00"1
10 hours of use
Retorq ue afte r
(22 Ibfoft)
Malenal: Steel bar 9.5 mm 1301"1 thickness cold rolled
AOO7003009
NOTE: For an accurate torque wrench reading ane must use the follaw:ng formulas: Torque wrench
length cm(io) Tarque wrench length4.44 em (1.750 in) Torque wrench reading Correction factarCorrection factor
33, Cotter pin
Reinstall new cotter pin be checked whenever pulleys have been removed, replaced or disassembledFor pulley alignment procedure see section 03-05
'W' CAUTION: Drive pulley alignment should always
= Real reading
14,16,44, Adjuster nut, jam nutLoctite 271
Apply Loctite 271 or equivalent on threads of both nutsTorque jam nut to 60-70 N-m (45-52 Ibf,ft)To torque the jam nut, it is necessary to make the fallowing tool or use Snap On crowfoot wrench naFC-