1986 Ski-Doo Factory Shop Manual, Page 277Get this manual
Section 03 TRANSMISSIOil Sub':section 03 (DRIVE PULLEY)
Slit against screw head
Pushing and urning Duller
10'600'012
Torque screws 10 10 N-m (89 Ibf-in)
Fully screw puller while holding mner halfUft outer half
against spring cover and align spring cover arrow with outer half mark
4,8,' 0,12, Lever ass'y, cotter pin, screwnut
Always install lever assemblies so that cotter pins are at the shown sideBesides install cotter pin head on top when lever is sat at bottom of outer halfBend cotter pin ends to sit perfecTly against leverHead Or'l
All on same side
,",0150[}JOI3