1986 Ski-Doo Factory Shop Manual, Page 276Get this manual
Saction 03 TRANSMISSION
Sub-section 03 (DRIVE PULLEY)
, CAUTION: Bushing must be bonded with Loctite "601 then flared to prevent displacement in spring covelTo flare bushing, use following tool:
23.24,25, Calibration screw, washerlocking nut
When installing calibration screw, make sure to install washer as shown
11010001012
Cover Ilare tool PIN 529 0059 00
Apply Loctite 601 outside of bushing then insert flush to spring cover (spring sidei, Torque locking nut to 10 N-m {B9 Ibf-inl
20,21,22, Ramp, dowel tubescrew
Bushing flush
to cover