1986 Ski-Doo Factory Shop Manual, Page 270Get this manual
Section 03 TRANSMISSION Sub-section 03 (DRIVE PULLEY)
Apply Loctite 271 all "Ouralon" bushingDo not fill set screw holes with LoctiteApply Loctite 242 on set screw threads, then tighten until screw slightly rests against bottom of "Ouralon" bushing hole
NOTE: On Formula MX models the shouldered washer 17 must be in position in governor cup because the ramps must be aligned with the edge of the shouldered washer center holeSee illustrationShouldered washer
21,29, BushingsLoctite 242
Gently grind sma!! chamfer at one end to ease bushing assemblyApply Loctite 242 outside of bushing then push into hub plug as illustrated above
25.28.29, Bushings, RollersLoctite 242
At assembly, apply Loctite 242 outside of bushing then push into folier
Governor cup -1"'1
21 to 27, Counterweight ass'y
Rollers and nylon washers must move freely; install them as per illustration
"011lC03021
W' CAUTION:
(TYPICAL)
Counterweights and rollers must move easily after Installation
Torque cap screws as per Illustration and check that ramps are still aligned, bend locking tab over bolts