1986 Ski-Doo Factory Shop Manual, Page 257Get this manual
Section 03 TRANSMISSION Sub-section 03 (DRIVE PULLEY)
,PpIY LOClil9 601 outsIde of bushing then insert imo its Dusing from the shown side, (So that using housing hamferl
To tigmsn Inner half, use protective sleeve as shown in the removal procedure
5, Shim (neutral)
This shim is used to obtain neutral function of the drive pulley when engine is idling: use required, maximum of two (2)Refer to ADJUSTMENT
1,4,6, Cap screw, governor cup, outer half
Insert from ,hiS side
Install governor cup correctly as per illustration making sure that the rollers are Sliding on their ramp
CAUTION: Ensure rollers are in good condition'Y' Replace as required
ush until bushing comes flush with its housing
2,13,14,15, Counterweight ass'y
pply Loctite 242 or equivalent on threads thero torque uts to 16 N.m (142 Ibl-in!
"CAUTION: Counterweights and rollers must Y' move easily after installation