1986 Ski-Doo Factory Shop Manual, Page 172Get this manual
Section 02 ENGINE SUb-section 08 (532 ENGINE TYPE)
- tighten puller bolt and at same timetap on bolt head using hammer to release magneto from its taper,
2, Generating coil
To replace generating coil:heat the armature plate around the screw holes to break the Loctite bond 93C (200F)f
Eye connector
AO01002005
5,7, Generating coil screwLoctite 242
To Install the new coil on the armature plate, remove the shipping nuts from the new coil and apply Loctite 242 (blue, medium strength) to screws before assembly,
W" CAUTION: Before reinstalling the magneto, move the loose epoxy from harnessHeal
prOtuCI
To replace lighting coilHeat the armature plate around the screw holes to break the Locttte bond 93C (200"FI
from h;Jme