1986 Ski-Doo Factory Shop Manual, Page 142Get this manual
Section 02 ENGINE SUb-section 06 (467 ENGINE TYPE)
Installation on spare crankcase without mark (ridgel
REQUIRED TOOLS
From top edge of magnelO side inlet port, marl crank-
case at 52
Degree wheel
OI300l021
(414362900)
To correctly install the rotary valve disc proceed as follows:
- Turning crankshah counter-clockwise, (drive pulley side) bring magneto side piston to Top Dead Center using T.D.Cgauge
100000086
- Position the rotary valve disc on gear as close as possible to the marks
to have edges
ENGINE TYPE