1986 Ski-Doo Factory Shop Manual, Page 141Get this manual
Section 02 ENGINE Sub-section 06 (467 ENG INE TYPE)
19.20,21, Bearing 6201, sealsdistance ring
22,23, Pump housing boltsLoctite 242
Apply Loctite 242 on bolt thread,
NOTE: After seats installation, check if the water pump end beanng IS correctly positioned (use pusher PIN 420 876 500)
5, Rotary valve
Installation on genuine crankcase with mark (ridge)
REQUIRED TOOL
Crankshah lOCking 1001
PIN 420 876 640
AOOO0010l9
To correctly install the rotary valveproceed as follows:
- Turning crankshaft counterclockwise, drive pulley side) bring magneto Side piston close to Top Dead CenteL Insert crankshaft locking tool while turning crankshaftWhen the crankshaft stops !t will be the right position