1986 Ski-Doo Factory Shop Manual, Page 127Get this manual
Section 02 ENGINE Sub-section 06 (467 ENG INE TYPE)
20, Crankcase studs
Because or cap nuts, cylinder studs have to be screwed into the crankcase so that they do not protrude by more than 56.5 mm (2.2")
used to align the cylindersPrior to torquing crankcase cylinder nuts, install tool PIN 420 876 900 (or exhaust manifold itself) to properly align exhaust flanges
Apply Loctite 242 (bluemedium strength) on the threaded end of the studs gOing into the crankcase
12,21 Cylindercylinder head stud
Because of cap nuts, cylinder head studs have to be screwed into the cylinder so that they do not protrude by more than 43 mm (1700") If it is not possible to obtain this lengthadd washer between cylmder head and cap nut Shorter threaded part of stud should be screwed intocylillder,