1986 Ski-Doo Factory Shop Manual, Page 111Get this manual
Section 02 ENGINE Sub-section 05 (462 ENGINE TYPE)
- Remove screws luse Phillips no3 screwdriver- Remove the wire retaining clip from armature plate- Pull out protector tubes and unsolder the splice connectors- Solder the yellow wire in the harness to the white tube protected wire of the coil- Solder the yellowblack striped wire in the harness to the black tube protected wire of the coil
1,9, 10,1, 19, Armature plate, lock washers washers, Loctite 242screws
Position the armature plate on the crankcase aligning the marks on both partsPut drop of Loctite 2.42on screw threads and tighten
Clean crankshaft extension (taperl, Apply loctite 242 on taper
2.19,28.29Loctite 242, flywheel, lock washernut
Position woodruff key, magneto flywheel, lock washer on crankshaftClean nut threads and apply Loctlte 2.42{blue, medium strength) before tightening nut to 95 -m (70 Ibf-ftl,