1986 Ski-Doo Factory Shop Manual, Page 110Get this manual
Section 02 ENGINE Sub-section 05 (462 ENGINE TYPE)
NOTE: For the above procMure, the locking tYpe puller can be used witnout crankshaft locking tooL
PIN 420 B16 065
PIN 420 878
CAUTION: Replace the old wires in the connecT tor with the same color coded new wires- Install new receptacle connector to :Striped wire,
the blackyellow
- tighten pullet bolt and at the same time, tap on bolt head using hammer to release magneto from its taper,
'Armature plate assembly
To remove the armature plate:Remove Allen screws,
- To install the ground connector of the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the old wire,
- Solder an eye connector to the lead and fasten it under Ihe wire retaining clip
Wire retaining
- Take off the grommet from crankcase- Pull out the armature, being careful when passing the conneclorsthrough the crankcase
15,- Generating coil
To replace generating coil:
Eya connect{)r