1986 Ski-Doo Factory Shop Manual, Page 73Get this manual
Section 02 ENGINE Sub-section 03(377 ENG INE TYPE)
18, Magneto flywheel
To remove magneto housing (flvwheel):
-lock crankshaft with crankshaft locking tool )service tool) and adjust magneto housing puller and puller ring Iservice to all as illustrated
Prolec.t harness
from flame
AOO100200J
: PIN 420 876 065
CAUTION: Protect harness from flame
- Remove screws (use Phillips no2 or suitable flat screw driverL
- Cut the four wires as close as possible to the coil body,To pass new coil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube-Insert the new wires into the old connector housing and install connectors