1985 Ski-Doo snowmobile Service Manual, Page 437Get this manual
Section 06 STEERINGSKIS Sub-section 01 (STEERING SYSTEM)
On all vehicles, adjust the steering handle to the desired positionLock the handle in place by tightening the four (4) nuts to 26 N.m (19 Ibf.ftl CAUTION: Tighten the nuts equally in crisscross sequence and ensure there is an equal gap on each side of the clamps
All models (except Alpine, Formula MX, Formula Plus)
Check that handlebar is horizontal while skis are parallel with the vehicleTo correct loosen shorter tie rod jam nuts Turn tie rod manually until handlebar is horizontal Tighten jam nuts firmly
Alpine 38,39, Steering armski leg
AOQ10060QJ
When assembling steering arm and ski leg the handlebar must be horizontal with the ski in line with the vehicle
WARNING: Do not adjust the handlebar too high to avoid contact between the brake lever and windshield when turningWARNING: Make sure that the steering pad and all controls are properly fixed to their normal lo cation on the handlebarCAUTION: Plastic alloy components such as fuel tank, levers, console, etccan be cleaned using mild detergents or isopropyl alcoholDo not use strong soaps, degreasing solvents, abrasive cleaners, paint thinners, etc