1985 Ski-Doo snowmobile Service Manual, Page 423Get this manual
Section 05 SUSPENSION Sub-section 07 (DRIVE AXLE)
12,13, Cap screwselastic stop nut
On Elan and Alpine, tightening torque for axle flanges is N-m (38 Ibf.in)When reassembling, install new nut or apply Loctite (or equivalent) on old threads, Tighten in the following sequenceTorque sequence
AOOOOO5008
APPLICABLE MODELS
Citation lS, lSE Tundra, Tundra IT Skandic Skandic Safari 377, Mirage III, Formula SS Safari 377 E, 447, Grand luxe, Formula SP Formula MX Formula Plus
"A" mm (in) 135 (5 83 (3 91.7 (3 146 (5 113 (4
5116) 17164) 39'64)
"S" mm (in) 138 (5 242 (9 242 (9 242 19
7116) 17132)
AOOOOO5011
1,4,5, Drive axleseal
When assembling drive axle, always position new seal on each end of drive axle (if applicable)The seal lip must face sprocket as illustrated