1985 Ski-Doo snowmobile Service Manual, Page 325Get this manual
Section 03 TRANSM ISSION Sub-section 08 (GEAR BOX)
NOTE: Assemble bearing must not project out of planet wheel
6, Transmission lever handle
Put Loctite 242 on handle threads
20,36, Carrier assembly
Apply Loctite 262 in planet wheel shaft boresWith planet wheel installed on shaft, press shaft into carrier bore Apply Loctite 262 on shaft threadsInstall and torque nut to 35 N.m (26 Ibf.ftl
47, Tensioner ass'y
Ensure that roller turns freely
67, Grease fitting
At grease fitting assembly, apply Loctite 262 on grease fitting threads
21, Planet carrier bearing
With suitable pusher, press bearing into carrier bore and lock in place with snap ring
66, Seal (countershaft)
Install seal in transmission case so that the seal rib is seated in the bore groove
18, Ring gear needle bearing
The bearing is press fitted into the ring gear and must be pushed down only from its stamped end
r CAUTION:
Never pound the bearing into its housing with hammer or other impact tool, even in conjunction with the proper assembly mandrel