1985 Ski-Doo snowmobile Service Manual, Page 301Get this manual
Section 03 TRANSMISSION Sub-section 06 (BRAKE)
ASSEMBLY
21, Ratchet wheel
Apply low temperature grease on threads and spring seat prior to installation Fully tighten then back off 12 turn
ADJUSTMENT
Lever travel
To insure optimum self adjusting function of the ratchet, screw the adjuster nut until there is gap of 57 mm (2 14 1,8") between lever and cable support lug
4,5, Inner shoe bolttab lock
Tighten bolt to 1.5 N-m (13Ibf-in) and secure with tab lock(Loctite 271 on Formula)
18,19, Caliper ass'y nuttab lock
With the release spring in position, slide the tab lock between the spring inner faces and secure the two caliper halves with nutsTorque nuts to 24 N-m (18 Ibfeft) Caliper half side slots must alignBend tab lock over float surface of nuts
Must be assembled from the pawl side and locked in the caliper casting recess to prevent from rotationAOl5C()3004