1985 Ski-Doo snowmobile Service Manual, Page 294Get this manual
Section 03 TRANSMISSION Sub-section 06 (BRAKE)
12345678910 1112
Cable Barrel Barrel Cotter Pin Brake mounting bracket Pin Shim Flat washer mm Elastic stop nut mm Flat washer 10mm Brake lever and pad Brake switch bracket
13141516171819
20212223
Taptlte screw M4 Bushing Release spnng Brake lever and pad Flat washer 10mm Elastic stop nut 10mm Pulley shaft Spring washer Pulley Stop plate Cotter pin
REMOVAL
Brake assembly
Disconnect brake light switch at connector and remove brake retainer nut, then pull out brake assembly, light switch and cableDisconnect and remove brake cable
18, Elastic stop nut
Torque to 12 N.m (9 Ibfftl
INSTALLATION
Reverse the removal procedure and pay particular attention to the following:
WARNING: Always readjust the brake light switch after removing the brake assembly