1985 Ski-Doo snowmobile Service Manual, Page 284Get this manual
Section 03 Sub-section 04
TRANSMISSION (DRIVEN PULLEY)
25,27, Roll pinouter cam
Remove roll pin and slide outer cam out of pulley shaft
ASSEMBLY
23, Sliding half bushing
Assemble new bushing uSing press and sUitable pusher
23, Sliding half bushing
To disassemble worn bushing, use press and suitable pusher
AOO7003007
Driven pulleychaincase
A0070QJOQ5
Assemble by reversing the disassembly procedure
INSPECTION
23, Sliding half bushing
Check sliding half bushing wear, replace bushing if wear is excessive
19, Fixed half shaft
, CAUTION: Always apply anti-seize compound on the pulley shaft before final pulley installation (Loctite anti-seize lubricant PIN 413 7010 00)