1985 Ski-Doo snowmobile Service Manual, Page 233Get this manual
DISASSEMBLYASSEMBLY
Section 03 TRANSMISSION Sub-section 01 (PULLEY GUARD)
PULLEY GUARD
Skandic models
When replacing the belt guard and brake support bracket, the support bracket must be leveled to ensure full contact of brake pad on diskUse shim as Illustrated belowtalog
NOTE: For additional Information (ex exploded view) refer to the 1985 correspondent parts ca-
WARNING: Engine should be running only when belt guard andor pulley guard are well secured in place
INSPECTION
ElanAlpine models
Check the spring loaded retaining pin for free operationReplace any damaged parts Prior to installation, ensure that pulley guard and frame bracket are 90 with frameAOO7003001