1985 Ski-Doo snowmobile Service Manual, Page 164Get this manual
Section 02 ENGINE Sub-section 08 (532 ENGINE TYPE)
2, Generating coil
To replace generating coilheat the armature plate around the screw holes to break the Loctite bond 93 (200 F)Eye connector
AOO 1002005
Wire retalrllng clip
5,7, Generating coil screwLoctite 242
To install the new coil on the armature plate, remove the shipping nuts from the new coil and apply Loctite 242 (blue, medium strength) to screws before assembly
Heat Protect harness from flame
A001Q020Q3
CAUTION: Before reinstalling the magneto, re move the loose epoxy from harnessTo replace lighting coil:Heat the armature plate around the screw holes to break the Loctite bond 93 (200 F)
TCAUTION: Protect harness from flame
- Remove screws (use Phillips no2 or suitable flat screw driver) Cut the four wires as close as possible to the coli bodyTo pass new coil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube- Insert the new wires into the old connector housing and install connectorsHeat