1985 Ski-Doo snowmobile Service Manual, Page 133Get this manual
Section 02 ENGINE Sub-section 06 (467 ENGINE TYPE)
19,20,21, Bearing 6201, sealsdistance ring
22,23, Pump housing boltsLoctite 242
Apply Loctite 242 on bolts thread,
NOTE: After seals installation, check if the water pump end bearing is correctly positioned (use pusher PIN 420 876 5001
2, Rotary valve cover bolts
Torque the rotary valve cover bolts to 20 N-m (15 Ibf-ft1
5, Rotary valve
Installation on genuine crankcase with mark (ridge)
REQUIRED TOOL
Crankshaft locking tool PIN 420 876 640
AOOOOO1039
To correctly install the rotary valve, proceed as follows: