1985 Ski-Doo snowmobile Service Manual, Page 126Get this manual
Section 02 ENGINE Sub-section 06 (467 ENGINE TYPE)
- Remove screws (use Phillips no2 or suitable flat screw driver)Cut the four wires as close as possible to the coil bodyTo pass new coil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube- Insert the new wires into the old connector housing and install connectors
To replace lighting coil:Heat the armature plate around the screw holes break the Loctite bond 93C (200FI
AOO 1002004
Protect harness from flame Heat