1985 Ski-Doo snowmobile Service Manual, Page 103Get this manual
Section 02 ENGINE Sub-section 05 (462 ENGINE TYPE)
- tighten puller bolt and at the same time, tap on bolt head using hammer to release magneto from its taper
1IIr CAUTION:
Replace the old wires in the connec-
tor with the same color coded new wires
1, Armature plate assembly
To remove the armature plate:Remove Allen screws- Take off the grommet from crankcasePullout the armature, being careful when passing the connectors through the crankcase
Install new receptacle connector to the blackyellow striped wire To install the ground connector to the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the oil wire Solder an eye connector to the lead and fasten it under the wire retaining clip
15, Generating coil
To replace generating coil:Heat the armature plate to 93 (200 F) around the screw holes to break the Loctite bond
Eye connector
AOO 1002005
1 8,19, Generating coil screwLoctite 242