1985 Ski-Doo snowmobile Service Manual, Page 67Get this manual
Section 02 ENGINE Sub-section 03 (377 ENGINE TYPE)
,CAUTION: Replace the old wires in the connec, tor with the same color coded new wires- Install new receptacle connector to the blackyellow striped wire- To install the ground connector of the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the oil wire- Solder an eye connector to the lead and fasten it under the wire retaining clip
CAUTION: Protect harness from flame
- Remove screws (use Phillips no3 screwdriverlRemove the wire retaining clip from armature plate- Pull out protector tubes and unsolder the splice connectors- Solder the yellow wire in the harness to the white tube protected wire of the coil- Solder the yellowblack striped wire in the harness to the black tube protected wire of the coil
Eye connector Black protector with yellowblack wire of harness