1985 Ski-Doo snowmobile Service Manual, Page 47Get this manual
Section 02 ENGINE Sub-section 02 (253 ENGINE TYPE)
- tighten puller bolt and at same time, tap on bolt head using hammer to release magneto from its taper
CAUTION: Replace the old wires in the connector with the same color coded new wires
18, Generating coil
To replace generating coil:Heat the armature plate to 93C (200F) around the screw holes to break the Loctite bond
- Install new receptacle connector to the blackyellow striped wire- To install the ground connector of the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the old wire- Solder an eye connector to the lead and fasten it under the wire retaining clip
Wire retaining clip
Eye connector
AOO1002005