1984 Ski-Doo Shop Manual, Page 382Get this manual
SECTION 07 CHASSIS SUB-SECTION 01 (HOOD)
To remove decal, pull it off Clean the surface Apply liquid soap on the new decalPosition the decal and pass sponge over it to remove air bubbles and waterAllow to air dry
WINDSHIELD TRIM INSTALLATION
Elan, Citation, Skandic, Blizzard 5500 MX, Blizzard 9700Alpine
Using rag, clean windshield mating surface Install trim with it's paper protector on windshield outside portion Gently pull out the paper protector as shown :
WINDSHIELD INSTALLATION
Elan, Citation, Safari 377E, 447, Grand Luxe, Sonic LlC, SS-25, Alpine
Peel off protective film from windshieldPosition the windshield on the hood then push it down until the tabs are fully inserted into the hood slotsLock the windshield tabs in position using the applicable "0" rings supplied in the kitNOTE: ELAN models: Do not install "0" rings on second and seventh tabs
trim Paper protector Gently pull
Ensure the trim is in place and adhere properly to windshield Cut excess trim length