1984 Ski-Doo Shop Manual, Page 376Get this manual
SECTION 06 STEERINGSKIS SUB -SECTION 02 (SKI SYSTEM)
Using steel bar, remove bushing
1,10, Stabilizer tubenuts
Hand tighten nuts so that stabilizer tube threads exceed equally on both sidesTorque nut to 35 N.m (26 ft.lbs)unscrew and retorque to Nm (0.7 ft.lbs) WARNING: Do not exceed Nm (0.7 ftlbs) on final torquing of nut
Criss-cross pattern
9, Lock tabs
Bend lock tabs
4, Stabilizer bar
Re install stabilizer bar
_ CAUTION: Always push out bushing in crisscross pattern
CLEANING
Clean all metal components in non ferrous metal cleaner
7,11,15,16, Swing arms, stabilizer arms, rubber washers, flat washers