1984 Ski-Doo Shop Manual, Page 323Get this manual
SECTION 05 SUSPENSION SUB-SECTION 01 (BOGIE WHEELS)
7, 2, Flanges nutsbolts
Bogie 'wheels are factory riveted When separation is necessary, remove rivets securing wheel tire and flanges by using 316" diadrill Secure flanges and tire using bolts and nuts tighten in the following sequence to N-m (3 .6 ft-Ibs)
1,14, Wheel supportelastic band
Torque sequence
INSTALLATION
3,4,5, Lock washers, cap screwscross shafts
With rear of vehicle supported off the ground, position front bogie wheel set in location and secure to frame using lock washers and cap screws Secure rear set then remaining set(s) to frame
On Alpine models it is necessary to place an elastic band between rear tube of front bogie and front tube of rear bogieThis will prevent center bogies from tipping upLubricate each bogie wheel until new grease appears at jointWipe off excess grease (grease PI 498 028 100)