1984 Ski-Doo Shop Manual, Page 238Get this manual
SECTION 03 TRANSMISSION
SUB-SECTION 06 (BRAKE)
789101112
Cable Barrel Barrel Cotter pin Brake mounting bracket Pin Shim Flat washer mm Elastic stop nut mm Flat washer 10 mm Brake lever and pad Brake switch bracket
1314157617181920212223
Taptite screw M4 Bushing Release spring Brake lever and pad Flat washer 10 mm Elastic stop nut 70 mm Pulley shaft Spring washer Pulley Stop plate Cotter pin
REMOVAL
Brake assembly
Disconnect brake light switch at connector and remove brake retainer nut, then pull out brake assembly, light switch and cableDisconnect and remove brake cable WARNING: Always readjust the brake light switch after removing the brake assembly
18, Elastic stop nut
Torque to 12 N-m (9 ft-Ibs)
INSTALLATION
Reverse the removal procedure and pa particu lar attention to the following: