1984 Ski-Doo Shop Manual, Page 229Get this manual
SECTION 03 TRANSMISSION SUB-SECTION 04 (DRIVEN PULLEY)
25,27, Roll pin and outer cam
Remove roll pin and slide outer cam out of pulley shaft
ASSEMBLY
23, Sliding half bushing
Assemble new busing using press and suitable pusher
23, Sliding half bushing
To disassemble worn bushing, use press and suitable pusher
sliding
bushing
Driven pulley and chaincase
Assemble by reversing the disassembly procedure
INSPECTION
23, Sliding half bushing
Check sliding half bushing wear, replace bushing if wear is excessive