1984 Ski-Doo Shop Manual, Page 225Get this manual
SECTION 03 TRANSMISSION SUB-SECTION 04 (DRIVEN PULLEY)
REMOVAL
To remove driven pulley assembly, carburetor, air silencer and steering column have to be removedFollow this procedure:
5, Sliding half bushing
To disassemble worn bushing, use press and suitable pusher
Pulley guard and drive belt
Remove from vehicle
Air silencer
Remove from vehicle
Carburetor
Disconnect carburetor rubber coupling at engine and move to side
Steering column
Disconnect steering column upper and lower attaching bracketMove steering to the formost right
INSPECTION
5, Bushing
Check sliding half bushing wear, replace bushing if wear is excessive
NOTE: Maximum right steering movement is obtained when skis are turned to right