1984 Ski-Doo Shop Manual, Page 216Get this manual
SECTION 03 TRANSMISSION
SUB-SECTION 04 (DRIVEN PULLEY)
INSPECTION
6, Sliding half bushing
Check sliding half bushing wear, replace bushing if wear is excessive
8, Cam Slider Shoe
When replacing slider shoes, always install new set of three shoes to maintain balanced pressures on the cam
8, Slider shoe
Check for excessive wear
INSTALLATION
Reinstall the driven pulley on countershaft by reversing the removal procedure
7, Spring torsional pre-load
Check pre-load using fish scale positioned at 90 with the pulley axleThe spring pre-load should be: 5,5 kg (12 Ibs 2)
13, Thrust washer