1984 Ski-Doo Shop Manual, Page 144Get this manual
SECTION 02 ENGINE SUB-SECTION 07 (534 ENGINE TYPE)
- Remove screws (use Phillips no2 or suitable flat screw driver)Cut the four wires as close as possible to the coil bodyTo pass new coil wires in harness, tape the old wires to the end of new wires and pull them through the harness protector tube- Insert the new wires into the old connector housing and install connectors
To replace lighting coil:Heat the armature plate around the screw holes to brea the Loctite bond (200 F)
Protect harness from flame Heat Insert new wires_=r
CAUTION: Protect harness from flame
- Remove screws (use Phillips no3 screwdriver)- Remove the wire retaining clip from armature plateCAUTION:
Replace the old wires in the connector with the same color coded new wires
- Pull out protector tubes and unsolder the splice connectors- Solder the yellow wire in the harness to the white tube protectd wire of the coilSolder the yellowblack striped wire in the harness to the black tube protected wire of the coil