1984 Ski-Doo Shop Manual, Page 141Get this manual
SECTION 02 ENGINE
SUB-SECTION 07 (534 ENGINE TYPE)
10,19, Seals
At seal assembly, apply light coat of lithium grease on seal lipsFor bearing lubrication purpose, gap of 1.0 mm (.040") must be maintained between seals and bearingsWhen installing plain seals (seal without locating ring or without spacing legs), ensure to maintain the specified gap as illustrated
NOTE: Torque the two smaller bolts (15 and 16) on magneto side to N-m (7 ft-Ibs)
1,3,8,29, "Loctite 242", angular tubes (oil inletoil outlet)cover screws
Apply "Loctite 242" on threads prior to assembly angular tubes and cover screws
27,31,32, Crankcase M8 screws
Torque the crankcase M8 screws to 22 N-m (16 ft-Ibs)
26, Crankcase M6 screws
Torque the crankcase M6 screws to N-m (7 ft-Ibs)
1,33, "Loctite 242"crankcase stud
At assembly on crankcase, apply "Loctite 242" on stud threads
35, Crankcaseengine bracket nut