1984 Ski-Doo Shop Manual, Page 101Get this manual
SECTION 02 ENGINE SUB-SECTION 05 (462 ENGINE TYPE)
- tighten puller bolt and at same time, tap on bolt head using hammer to release magneto from its taper
- Install new receptacle connector to the redblack wire (on 140W 4-4P models only)Install the ground connector to the armature plate as illustrated
1, Armature plate assembly
To remove the armature plate:Remove Allen screwsTake off the grommet from crankcasePull out the armature, being careful when passing the connectors through the crankcase'
15, Generating coil
To replace generating coil:Heat the armature plate around the screw holes to break the Loctite bond (200 F)
- To install the new coli on the armature plate, remove the shipping nuts from the new coil and apply Loctite 242 (blue, medium strength) to screws before assembly CAUTION: Before reinstalling the magneto, remove the loose epoxy from harnessProtect harness from flame