1984 Ski-Doo Shop Manual, Page 64Get this manual
SECTION 02 ENGINE SUB-SECTION 03 (377 TYPE)
- tighten puller bolt and at same time, tap on bolt head using hammer to release magneto from its taper NOTE: For the above procedure, the locking type puller can be used without crankshaft locking toolused without crankshaft locking tool
_ CAUTION: Replace the old wires in the connector with the same color coded new wires- Install new receptacle connector to the blackyellow striped wireTo install the ground connector of the armature plate, tape the new black lead to the old one and pull it under the lighting coil with the old wireSolder an eye connector to the lead and fasten it under the wire retaining clip
PIN 420 876 065
PIN 420 876 080
Wire reta ining clip
26, Generating coil
To replace generating coil:Heat the armature plate around the screw holes to break the Loctite bond (200 F)
Eye connector
- To install the new coil on the armature plate, remove the shipping nuts from the coil and apply Loctite 242 (blue, medium strength) to screws before assembly CAUTION: Before reinstalling the magneto, remove the loose epoxy from harness