1983 Ski-Doo Shop Manual, Page 259Get this manual
SECTION 05 SUSPENSION SUB-SECTION 04 (DRIVE AXLE)
ASSEMBLY
NaTE: 1983 models have two different axle-sprocket press fits Ensure to replace ring reinforced sprockets with the sam type
_ CAUTION: The same sprocket must not be pressed twice on the axleIf synchronization is found to be defective, use new sprocket
NOTE: Idler wheel G) must turn freely
To assemble press fit sprockets, use press and pipe (1 1 I.D as illustratedSprockets must be assembled with the following dimensions
Tightening torque for axle flanges is 3-4 N.m (2-3 ft -Ibs) When reassembling, install new nut or apply "Loctite" (or equivalent) on old threads Tighten in the following sequence