1983 Ski-Doo Shop Manual, Page 249Get this manual
SECTION 05 SUSPENSION SUB-SECTION 02 (SLIDEMX SUSPENSIONS) SHOCK ABSORBER SERVICING
The shocks may be checked by partially creating the operating positionTo do this, secure the proper shock end in vise using the shock eye as clamping point
INSTALLATION
Lift the rear of vehicle off the groundPlace suspension within the track and align front arm of suspension with front holes of frame and secure using bolts and washers Torque to 42 N-m (31 ft-Ibs)Raise the rear section of the suspension and track into the tunnel and align rear arm with rear holes in frameSecure to frame using bolts and washers Torque to 42 N-m (31 ft-Ibs)
) Secure shock absorbers to rear arm, torque bolt to 61 N-m (45 ft-Ibs)If necessary, lubricate the idler wheels at grease fittings until grease appears at jointsUse low tempera ture grease only (PIN 498028100) NOTE: To adjust the track tension and alignment, refer to section 05-05 WARNING: Ensure to install the special washer as illustrated or the shock absorber rubber bushing may slip out of their shock eye