1983 Ski-Doo Shop Manual, Page 216Get this manual
SECTION 04 ELECTRICAL SUB-SECTION 05 (ELECTRIC STARTER)
For asse mblyfollow the disassembly procedure In the reverse orderpaying attention to the following Coat the sliding surfaces and movi ng portions of the armature splinesoverrunning clutchbushings and the solenoid sWitch plunger with multipurpose grease (waterclimate and coldness resistant) Reinstall the drive lever as illustrated below
CLEANING
_ CAUTION: Armature starter yoke ass'y and driveunit assembly must not be immersed in cleaning solventClean brushes and holders with clean cloth soaked in solvent Brushes must be dried thoroughly with clean clothBlow brush holders clean uSing compressed airRemove dirtoil or grease from commutator uSing clean cloth soaked In sUitable solventDry well uSing cleandry cloth Clean engine starter gear teeth and drive unit (clutch)
Dnve lever Overrunning clutc h
NOTE: Bearing bushing of the drive unit must not be cleaned with grease dissolVing agents In
Immerse all metal components using cleandry cloth